AEM 30-3302, Water/Methanol Injection System (No Tank)

WHAT IT DOES
The AEM Water/Methanol Injection System injects a mixture of water/methanol into the intake of a forced induction engine. Injecting water/methanol allows users to run more boost and ignition timing to gain horsepower and torque. Gains as much as 20% more horsepower and 25% more torque on pump gas are common.

WHY YOU WANT ONE
The AEM Water/Methanol Injection (No Tank) System comes loaded with more STANDARD features and high quality components that any other comparably priced injection system on the market today – except the tank. This is the same as our 1 gallon kit, except it is intended for those who do not have room to mount even a one gallon tank, resulting in the use of the factory washer bottle. The “Boost Safe” injection readiness system comes standard in all AEM Water/Methanol Injection Systems. An check valve integrated into the nozzle prevents unintended fluid flow is included standard. One injector and three interchangeable nozzles are included to cover a wide range of potential horsepower levels along with 20 feet of injection tubing to facilitate the system being installed on practically any vehicle.

PRODUCT FEATURES

	Boost referenced progressive controller
	“Boost Safe” readiness safety system
	Check valve integrated into nozzle to prevent unintended fluid flow
	One injector and three nozzles to cover a wide range of HP levels
	High Pressure 200psi Recirculation-style pump
	Progressive Controller: Start Injection Boost 1-11psi. Full Injection Boost 6-39psi
	LED dash light for system status
	20 ft. of injection tubing

PRODUCT CONTENTS

PRODUCT REVIEW

PRODUCT CLOSE UPS

AEM Water/Methanol Injector Nozzle Close up (now with internal check valve!)

Newest Pump has hose fittings built into head of pump

Legal in California only for racing vehicles which may never be used upon a highway.

Note: FOR OPTIMUM RESULTS, ALL WATER/METHANOL INJECTION SYSTEMS AND GAUGES SHOULD BE RUN WITH AN AEM INLINE FILTER (AEM PART #30-3003)

Important Safety Notice Regarding Methanol

AEM strongly recommends that users never exceed a 50% methanol concentration when using any AEM Water Methanol system or component.

All AEM Water/Meth injection systems and components (pump, lines, fittings, filter, flow sensor, tank, and nozzles) are 100% chemically compatible with methanol. However, for safety reasons we strongly recommend that users never use more than a 50% methanol concentration in our systems.

Methanol is a toxic and highly flammable chemical. 100% Methanol ignites easily and burns vigorously with an almost undetectable flame. Methanol can be absorbed through the skin and even x-small amounts can cause blindness or even death. Using this fluid at high pressures, without dilution, in an under-hood environment with nylon lines and push-to-connect fittings is very unsafe. The performance advantages of using greater than 50% methanol concentrations are x-small, if they exist at all. However, the safety issues are very real and far out weigh any perceived benefit of running high concentrations of methanol.

WARNING!

Improper installation and/or adjustment of this product can result in major engine/vehicle damage.

Note: AEM holds no responsibility for any engine damage or personal injury that results from the misuse of this product, including but not limited to injury or death caused by the mishandling of methanol.